This is a small rotator that you can hang parts from (not to exceed 30 lbs in weight.) It has very sturdy construction. Convenient 3 pin plug with on/off switch.

Suggested Uses:

This unit makes the curing of an item easier just by scanning up and across the top and bottom at a distance of 6-8 inches. It will cure most coatings in a few minutes if you follow this procedure and with practice you will be very consistent with your cure.

Power Requirements:

• 110-120VAC 60Hz Fused

Dimensions & Weight:

• 4.25"wide x 5.00"high* x 4.25" deep to shaft end holder device approx another 3.00" Weighs 5 lbs

Operating Temperatures:

• Ambient between 60-100°F

RPM Color:

• 7 Grey

Warranties:

• 1 year parts.